The How to Guide to Repairing Overhead Warmers in Restaurants

in Element

Overhead warmers are fairly simple devices. They are typically used to keep food that is ready to be served warm before it goes out on the server's tray. Overhead warmers have three main parts:

1. Element

2. On/off switch

3. Infinite Control

Read on below for instructions on how to test and replace these three parts. Warmers come in different voltages such as 120V, 208V, and 240V, and they are made in different lengths. Always have the correct voltage on the unit! If you don't, severe damage to the unit can result. There are two types of elements in most overhead warmers.

1. Cal-rod (metal) type

2. Quartz glass type.

These elements vary in wattage and length. When replacing an element, it is helpful to provide the following information to ensure you get the correct element.

1. Overall length of the warmer

2. Model Number

3. Serial number

4. Voltage

This information can be found on the name tag that is attached to the warmer.

There are two ways to determine if an element is bad:

1. Visual Inspection. On the Cal-rod element, inspect the outside for burn marks. On the quartz element, inspect the filament or wire coil inside the glass tube. If it is separated in any way, it is burnt out.

2. Continuity Testing. A continuity tester can determine if an element is defective. Remember to disconnect the power! For either element (cal-rod or quartz), first remove at least one wire connection or remove the element if it is a socket type. If you have a Multi-Tester set your tester in the continuity position and touch the leads to the element. If there is no digital read out on the display the element is no good. If you're using a lighted tester and the light does not light up, then the element is not good. In either case, the element needs to be replaced. The element is still good if you get a digital read out or the lights does light up.

On/Off Switch

To test the on/off switch, disconnect at least one wire from the switch and perform a continuity test with the switch in the on position. If you do not get a reading, then you need to replace the on/off switch.

Infinite Control

To test the infinite control, there are multiple wire connections on the back of the control. These wire connections are marked as follows: L1 and L2 are the power wires coming in the warmer. H1 and H2 are the connections for the element wires. On units with a pilot light there may be a HP connection or a P connection, P meaning pilot light connection.

Disconnect at least one wire from any of the H connections and perform a continuity test across the H prongs with the control in the on position. If you did not get a reading or light it is time to replace the infinite control. On an infinite control make sure to determine if it is a screw mount or nut mount before purchasing a replacement. Screw mount controls screw into the overhead warming unit; nut mount controls bolt onto the unit.

Good testing and repair!

Author Box
Jerry H. Green has 1 articles online

Jerry H. Green is a restaurant equipment and equipment parts guru with over 25 years experience fixing commercial cooking equipment. He is a regular contributor to a food service industry and equipment blog called The Back Burner.

Add New Comment

The How to Guide to Repairing Overhead Warmers in Restaurants

Log in or Create Account to post a comment.
Security Code: Captcha Image Change Image
This article was published on 2010/03/30